How to Reset And Troubleshoot D-link Range Extender?

Wireless extenders or repeaters are extremely helpful as they extend the rand of your wireless network. Additionally, they make access to Wi-Fi a lot easier. Here, we are going to talk about all the troubleshooting tricks about how to reset and troubleshoot D-link Range Extender.

These expensive devices are quite popular as they are easily affordable and reliable. Some of the popular D-Link router models are N300, DAP-1320, etc. 

Step to Reset Troubleshooting for D-Link Range Extender

Below are some of the basic troubleshooting steps for a D-Link range extender. 

Step 1: Disconnect your range extender from the electrical outlet and then wait for at least 2 minutes. 

Step 2: Restart your router and modem. After that, try to connect the extender again. Also, check your modem for the internet as well. 

How to Troubleshoot and Reset D-Link Range Extender?

D-Link products are one of the best and most widely used products. You can easily find these devices in the networking centers. If you have a house that covers an area of 2,000 square feet, then you may face the problem of weak signal strength and hence you will need a wireless extender to increase the range of the network. 

You may encounter some technical problems while using your D-Link range extender. Worry not, as you can fix this problem by resetting your D-Link range extender. 

Step to Dlink Wifi Extender Reset

Below is the step-by-step process that you need to follow to dlink wifi extender reset 

Step 1: To begin with the reset process, you need to first connect your dlink wifi extender reset to the power source. Once your device is fully turned on, the LED light on your device will either change to red or green based on the color that your range extender shows. 

Step 2: On the lower side of your D-Link range extender, you are going to see a pinhole button that is a reset button. Also, you need to use a paperclip to press it and then you are required to hold it for the next 10 seconds. After that, the led light will either start blinking or it will change to a different color i.e., Orange, Blue, or Green. 

Your extender will restart and will be reset to factory default settings. Sometimes, it can be extremely troublesome to reset a D-Link range extender and therefore, you must try to troubleshoot some common issues that may occur on your device. 

How can I Log in to a D-Link Range Extender?

If you are encountering any issues, then you must first check the IP address of your D-Link extender. This utility is actually built on the ROM of your device that enables you to configure your device. 

• See if you are on the same subnet mask as your device. 

• Check whether you have a Java-enabled web browser. D-Link strongly recommends Milla Firefox 3.0 or higher. If you are using Google Chrome, then you must use Chrome 2.0 or higher. 

• Also, you need to check whether the connection between your PC and router is working or not. All you have to do is to take a look at the LED of your D-Link range extender. 

• Disable antivirus on your computer. It may act as a firewall and may not let you access the page.