How To Reset Dlink WiFi Extender?

Dlink Wi-Fi Extender is one of the most sought-after range extenders when it comes to augmenting the reach of the internet in your home or office. But many a time using Dlink Wi-Fi Extender may trigger problems in its performance ultimately prompting you to Reset Dlink WiFi Extender. This quick guide is here with certain feasible solutions to help you Reset Dlink WiFi Extender effectively.

App-Based Soft Reset Methodology for your Dlink Wi-Fi Extender

There is always a setting-based management tool in the wizard section that can often set gadgets up and running efficiently which is available in the case of Dlink Extender as well. Just go through the steps discussed below to reset Dlink Wi-Fi Extender using the app-based Soft Reset methodology.

Step 1 - Make sure that your PC or device is connected to the Dlink Wi-Fi network before embarking on the task of resetting the Dlink Extender.

Step 2 - Now log in to the Dlink Extender setup wizard followed by accessing the “Device Administration” segment of the wizard.

Step 3 - Continue to navigate the “Menu” section followed by choosing to click the “Reset” device option.

Step 4 - If prompted to enter the password, you must punch in the same followed by clicking the “Reset Extender Immediately” option going forward.

Step 5 - After the Soft Reset operation is carried out successfully, just log out of the wizard and modify the “Network Settings” to seamlessly reset Dlink Wi-Fi Extender comprehensively.

The conventional Hard Reset technique

When nothing works from the app-based methodology to effectively help you reset Dlink Wi-Fi Extender, the conventional Hard Reset technique can be applied to reset Dlink Wi-Fi Extender. This Hard Reset technique is simple and can be effectuated in a few steps mentioned below.

Step 1 - In the very first step you must locate the “Reset” button on your Dlink Extender. Here are a few possibilities as to where the “Reset” button might be present on your Dlink Extender.

• On the rear portion of the Dlink Extender

• At the bottom panel of the Dlink Extender

• In a partially concealed covering within the hole at either side of the Dlink Extender.

So, the next time you are up for executing a Hard Reset on your Dlink Extender, don’t forget to look at all the above spots on your Dlink Extender to be successful in finding the “Reset” button.

Step 2 - After you have found the “Reset” button, you have to press it for 6 seconds at least. Please do remember that you can press the “Reset” button using your finger or you can also use a small needle, paper clip, or hairpin to press the same.

Step 3 - As a result of holding the “Reset” button you must start seeing the flashing of the “Power” and “Status” LEDs simultaneously which will be an indication that you have been apparently successful in resetting the Dlink Extender.  

A couple of don’ts while executing a Hard Reset

1 - While the process of the Dlink Hard Reset is underway do not attempt to turn off your Dlink Extender as doing it may seriously damage your Dlink Extender.

2 - You should ensure to follow the basic Dlink Setup instructions after executing the Hard Reset in a bid to get your Dlink Extender running.